Pressure Washing Basics

When pressure washing a wooden deck, you need to be extra careful to avoid damaging the wood. You should not linger on one spot for long, and you may have to make several passes over the same area before you get the desired effect. You should also avoid making overlapping strokes on the same spot. In addition, you should use protective gear to prevent skin damage.

Soft washing

Soft washing is a way to clean without using high pressure. Instead of washing with high pressure, this method uses a combination of high concentration cleaning solutions and water. A professional soft washing company has access to chemicals that are biodegradable and eco-friendly. The solution used by soft washing companies can be adjusted to suit the type of surface being cleaned.

Pressure washing is often necessary to remove tough stains, but soft washing is the better choice for delicate surfaces. Soft washing is also better for surfaces that have adhesives and are made of durable materials. A pressure washer can remove stains, but soft washing removes biological elements and chemicals from the surfaces.

Harder spray

When pressure washing, it’s important to choose the correct nozzle to get the best results. Depending on the application, you may want to use a 0-degree spray or a 40-degree spray. A 0-degree nozzle will cover a smaller area but produce a harder spray. This type of nozzle is most appropriate for removing clumps of dirt, algae, mud, and stains. A 40-degree nozzle is best for house siding and patios.

The spray should be applied at a slightly angled angle to lift dirt from the surface. This angle is important because spraying directly at a surface will drive the dirt deeper into the surface. If the dirt is ground-in or has a hard stain, it may be necessary to move the spray head. In any case, you should move forward until the pressure washers near Cheswick pa pressure of the spray is strong enough to remove the dirt.

Cold water

There are two main types of pressure washers: hot and cold. Hot water pressure washers are more expensive and more complex than cold water machines, but they are recommended for more experienced users. Cold water pressure washers can clean surfaces with mud or oil, while hot water units can effectively remove greasy stains. Hot water pressure washers are also more complicated and require more maintenance. You should choose the one that is right for your needs.

Cold water pressure washers work by applying a pressurized water jet to loosen dirt and grease. This force breaks the chemical bonds between dirt and the surface, and removes most types of impurities. They’re less effective on tough stains like oil or grease, though detergents are available to tackle those kinds of stains.

Protective gear

Wearing the right protective gear while pressure washing is essential. Wearing a safety suit and a sturdy work glove will protect your hands from flying debris, and will help you grip the washer gun more securely. You can also use earmuffs to protect your hearing from the high decibels.

Protective gear is especially important if you have a power washer. These high-pressure jets can slice through skin and cause serious injuries. You should also wear safety glasses, goggles, and a long-sleeve shirt or jacket. It is important to always wear protective gear, and to check it regularly.

Cost

The cost of pressure washing depends on several factors, including the size of the area and the type of material that needs cleaning. Typically, it will cost less per square foot if the area is not very dirty. In contrast, if the surface is extremely dirty, a higher pressure will be necessary to thoroughly clean it.

The cost of pressure washing varies widely from region to region. However, the general cost for a basic job is between $180 and $380. The price for pressure washing can be quoted in several ways: by the square foot, per hour, or as a flat rate. The average charge in each of these scenarios is about $0.08 per square foot. In addition, the cost may increase if there are issues with the property that need to be addressed.